0v7670 Camera Module Without FIFO
This is an Arduino camera module, adopted the Surveillance cameras digital image processing chip-OV0706, specially designed for image acquisition and processing application, based on TTL communication interface, very convenient to connect with Arduino controller, able to read image and data via UART serial port, and then perform some image processing.
Brand new and high quality.
High sensitivity for low-light operation.
Low operating voltage for embedded application.
Standard SCCB interface compatible with I2C interface.
Raw RGB, RGB (GRB4:2:2, RGB565/555/444),YUV(4:2:2) and YCbCr(4:2:2)output format.
Support VGA, CIF and from CIF to 40 x 30 format.
Vario Pixel method for sub-sampling.
Auto Image Control: AEC, AGC, AWB, ABF, ABLC.
Image Quality Control: Color saturation, hue, gamma, sharpness and anti-blooming.
ISP includes noise reduction and defect correction.
Support image scaling.
Lens shading correction.
Flicker 50/60Hz auto detection.
Color saturation level auto adjust.
Edge enhancement level auto adjust.
De-noise level auto adjust.
Photosensitive Array: 640 x 480.
IO Voltage: 2.5V to 3.0V.
Operating Power: 60mW/15fpsVGAYUV.
Sleeping Mode: <20?_A.
Operating Temperature: -30 to 70 deg C.
Output Format: YUV/YCbCr4:2:2 RGB565/555/444 GRB4:2:2 Raw RGB Data (8 digit).
Lens Size: 1/6??_.
Vision Angle: 25 degree.
Max. Frame Rate: 30fps VGA.
Sensitivity: 1.3V / (Lux-sec).
Signal to Noise Ratio: 46 dB.
DynamicRange: 52 dB.
Browse Mode: By row.
Electronic Exposure: 1 to 510 row.
Pixel Coverage: 3.6?_m x 3.6?_m.
Duck Current: 12 mV/s at 60䋀.
PCB Size (L x W): Approx. 1.4 x 1.4 inch / 3.5 x 3.5 cm.