Stepper Motor Driver DRV8825

This product is a carrier board or breakout board for TI??s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for more information). Here are some of the driver??s key features:

    Simple step and direction control interface
    Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
    Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor??s rated voltage to achieve higher step rates
    Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
    45 V maximum supply voltage
    Built-in regulator (no external logic voltage supply needed)
    Can interface directly with 3.3 V and 5 V systems
    Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
    Short-to-ground and shorted-load protection
    4-layer, 2 oz copper PCB for improved heat dissipation
    Exposed solderable ground pad below the driver IC on the bottom of the PCB
    Module size, pinout, and interface match those of our A4988 stepper motor driver carriers in most respects
₹169
Excluding Tax: ₹31
Stock Status: Order with good quantity to explore best price

Pcs